Busted RC Props. Forum

General Category => General Discussion => : Walter Johnson May 31, 2014, 07:17:01 PM

: F-22 Raptor Twin EDF
: Walter Johnson May 31, 2014, 07:17:01 PM

  Here are the pics of my RBC kits F-22 Raptor build in process. The specs are as follows twin Wemotec 70mm fans with Mega 16-15-3 motors and 55 amp esc's one 4 cell 3300 mah pack which will give her more than 1-1 thrust to weight ratio. Airframe is 43 inches long with a 33 1/2 inch wingspan. Controll system is a simple ailivators set up which is the same as a delta wing set up but uses the elevators instead of the ailirons for control two Hitec HS85MG servos and a 6200 Spectrum reciever Castle 10amp BEC. The jet will be bungee launched off a pvc pipe ramp and will belly land.BCNU Walter 

: Re: F-22 Raptor Twin EDF
: fmeyerrc June 03, 2014, 05:35:01 PM

Can't wait to see it fly.  Will it be a 3D aircraft?

: Re: F-22 Raptor Twin EDF
: Walter Johnson June 07, 2014, 02:38:16 PM

 Hi Fred, Nope no 3d should move along quite nice with some good verticle rolls loops ect going to be good fun I'm sure.BCNU Walter ;)